TRAIN SMARTER
NOT HARDER

Every movement with step-by-step instructions, the muscles it works, common mistakes and form tips — free, no account needed.

Browse by Muscle Group
Browse by Training Style
Browse by Equipment
0 Exercises
Clear
Cable Rear Drive
HomeTriceps › Cable Rear Drive

Cable Rear Drive

Triceps Cable Machine Push Hypertrophy
Difficulty: Intermediate Equipment: Cable Machine Primary: Triceps Secondary: Anconeus, Forearms

Overview

The Cable Rear Drive trains the triceps using cable machine, and sits at a intermediate level of technical demand. Mechanically, the target muscles straighten the elbow — the reason this exercise carries over to lockout strength on every press. What separates this variation from other triceps work is that it is emphasising a posterior emphasis — a detail that changes which fibres take the load and how much stability the movement demands. The 'Rear Drive' designation is not cosmetic — it tells you the specific setup and line of pull that separates this from its close relatives. Support comes from the anconeus and forearms; the anconeus in particular help contribute to the movement, which is why fatigue there often shows up before the triceps is fully worked. Training this with cable machine keeps constant tension on the muscle through the entire range, though it requires an available station and correct pulley height. Most lifters place the Cable Rear Drive in the first half of a triceps session. It assumes you already own the basic pattern and can maintain position under moderate load.

Muscles Worked

The Cable Rear Drive is primarily a triceps exercise, but it is never only the triceps doing the work.

Triceps
75%
Anconeus
42%
Forearms
32%
  • Triceps (primary) — These fibres straighten the elbow, and they carry the majority of the load in this movement.
  • Anconeus (secondary) — Assists by helping to contribute to the movement, contributing to overall performance in this pattern.
  • Forearms (secondary) — Assists by helping to control the wrist and maintain grip, contributing to grip endurance and carryover to every pulling lift.

Benefits of the Cable Rear Drive

  • Uses cable machine, which keeps constant tension on the muscle through the entire range.
  • Allows progressive overload — adding load or repetitions over weeks is what actually drives triceps growth.
  • Builds strength in the triceps through a push pattern, which carries over directly to pressing resistance away from your torso.
  • Reinforces the chest, shoulders and triceps working as a unit as a coordinated unit rather than as isolated parts.

How to Perform the Cable Rear Drive

  1. 1
    Set the pulley height for the movement and take a stable stance.
  2. 2
    Take a breath and brace, then press the handle away from your body under control.
  3. 3
    Press until your arms are almost straight, stopping just short of locking the elbows.
  4. 4
    A good Cable Rear Drive rep looks identical to the one before it; when it doesn't, the set is done.
  5. 5
    Lower back to the start slowly, feeling the triceps lengthen under tension.
  6. 6
    Breathe out through the effort and keep the triceps under tension between reps.
Your Goal General Fitness
Sets
2–3
Reps
10–15
Rest
60s

Breathing Technique

The general rule for the Cable Rear Drive is simple: inhale as you lower the resistance toward you, exhale as you press it away. For heavier sets, take a breath in at the start position, brace as though bracing for a punch, and hold that pressure through the hardest part of the rep before exhaling. If your breathing falls apart, it is usually the first sign the set has gone past useful.

Tips for Proper Form

  • Control the lowering phase — most of the triceps stimulus comes from resisting the weight, not lifting it.
  • Keep the range of motion consistent across every rep so you can compare sessions honestly.
  • Set your position before the first rep rather than correcting it mid-set.
  • Keep the a posterior emphasis deliberate rather than letting momentum carry it.
  • Step far enough from the anchor that there is tension on the muscle before the first rep begins.
  • Keep the shoulder blades set down and back so the shoulder joint stays in a safe position.
  • Keep your elbows at roughly 45 degrees from your torso — flaring them wide shifts stress to the shoulder joint.
  • Expect to feel the Cable Rear Drive in your anconeus and forearms as well as the triceps — that's normal, but if the anconeus and forearms fatigue first, revisit your setup.
  • Set the pulley height first. A few inches either way changes which part of the muscle takes the load.

Common Mistakes to Avoid

  • Bouncing the weight at the bottom of the rep.
    Do this insteadPause briefly at the bottom so the triceps does the work instead of the stretch reflex.
  • Copying someone else's Cable Rear Drive setup without adjusting for your own build.
    Do this insteadLimb lengths change what a good position looks like; adjust until you feel it in the triceps.
  • Letting the stack touch down between reps and killing the tension.
    Do this insteadStop just short of the stack — constant tension is the whole reason to use a cable for the triceps.

Variations by Experience Level

Beginner

Shorten the range of motion to the portion you can control, then extend it as confidence builds. If cable machine feels unmanageable, rehearse the same pattern with bodyweight first. Treat the Cable Rear Drive as skill practice at this stage — the triceps adapts plenty from clean reps.

Intermediate

Add load in small increments while holding the same tempo and range you established. Alternate harder and easier Cable Rear Drive sessions rather than pushing every one.

Advanced

Add a drop set on the last working set to extend the stimulus beyond your normal stopping point. Small, tracked increases on the Cable Rear Drive beat occasional maximal efforts.

Safety Considerations

  • Stop the set when technique degrades — a Cable Rear Drive rep that no longer looks like your first one is not building anything.
  • Warm up with lighter sets of the Cable Rear Drive before your first working set.
  • The most common way the Cable Rear Drive goes wrong is shoulder impingement when the elbows flare excessively.

Who Should Avoid This Exercise

The Cable Rear Drive suits most healthy trainees, but it is not appropriate for everyone.

  • Anyone experiencing sharp, localised or radiating pain during the movement — that is a signal to stop, not to push through.
  • Anyone with active elbow tendinopathy, since repeated loaded flexion or extension tends to aggravate it.
  • Anyone with an unresolved shoulder impingement or rotator cuff issue, since the pressing position loads exactly that structure.

This is general educational information, not medical advice. If you are managing an injury or medical condition, check with a qualified professional before adding this exercise to your programme.

Frequently Asked Questions

What muscles does the Cable Rear Drive work?

It primarily trains the triceps, with the anconeus and forearms assisting. The pattern is classified as push, so the chest, shoulders and triceps working as a unit share the workload.

Is the Cable Rear Drive suitable for beginners?

It is rated intermediate. You should already be comfortable with basic triceps work and able to hold position under moderate load before attempting it.

How many sets and reps should I do?

A practical starting point is 4 sets of 8-12, resting 60-90 sec between sets, roughly 2x per week. Adjust from there based on how you recover.

What equipment do I need for the Cable Rear Drive?

You need cable machine. This keeps constant tension on the muscle through the entire range, though it requires an available station and correct pulley height.

How do I breathe during the Cable Rear Drive?

As a general rule, inhale as you lower the resistance toward you, exhale as you press it away. Avoid holding your breath for the entire set.

What is the most common mistake with the Cable Rear Drive?

Shoulder impingement when the elbows flare excessively. The simplest correction is to keep the shoulder blades set down and back so the shoulder joint stays in a safe position.

What can I do instead of the Cable Rear Drive?

Good substitutes that train the same triceps pattern include Band Triceps Pushdown Single Arm, Band Lying Press Down, and Elbow-extension. Pick whichever matches the equipment you have available.

How do I progress the Cable Rear Drive over time?

Add a small amount of load once you can complete every set at the top of the rep range with clean technique. Keep tempo and range consistent so the comparison is honest.

About Training Your Triceps

The Cable Rear Drive fits into that picture as an intermediate option using cable machine, leaning on the anconeus and forearms alongside the triceps.

The triceps brachii makes up roughly two-thirds of the size of your upper arm, which means that if your goal is bigger arms, the triceps deserve more attention than the biceps. As the name suggests, it has three heads — the long, lateral, and medial heads — and its primary job is to extend the elbow, straightening the arm. The long head also crosses the shoulder joint, so it is involved in pulling the arm down and back.

Because the three heads have slightly different functions, varied exercise selection produces the most complete development. Heavy compound pressing such as the close-grip bench press and dips trains all three heads under significant load and builds raw size and strength. Pushdowns with a rope or bar isolate the lateral head, which gives the arm its width when viewed from the side. Overhead extensions — where the arm is raised above the head — place the long head on a deep stretch and are essential for filling out the back of the arm and creating the horseshoe shape.

Triceps respond well to a mix of rep ranges. The heavy presses can be trained in the 6 to 10 range, while cable and overhead isolation work is best in the 10 to 15 range with strict form. Like the biceps, the triceps recover quickly and tolerate being trained a couple of times per week, especially when some of that volume comes from your pressing work for chest and shoulders.

A frequent error is letting the elbows drift and flare on extensions and pushdowns, which turns the movement into a shoulder and chest exercise. Keep the upper arms relatively fixed so that only the forearm moves, and lock out each rep fully to maximise the contraction at the medial head. On dips and close-grip presses, keep the elbows tucked rather than flared to protect the shoulders and bias the triceps.

Developing the triceps not only adds the majority of your arm size but also directly increases your pressing strength on the bench and overhead press. A balanced arm routine gives the triceps at least as much attention as the biceps. Build yours around the popular triceps exercises listed below.

Popular Triceps exercises:
Add to workout