Every movement with step-by-step instructions, the muscles it works, common mistakes and form tips — free, no account needed.
Among back exercises, the Resistance Band Kneeling Cross Body Single Straight Arm Supinated Pulldown stands out as a pull movement performed with bodyweight. The working muscles pull the arms toward and behind the torso, which is what makes this movement valuable for posture, pulling strength and shoulder health. What separates this variation from other back work is that it is performed from a kneeling position, using a supinated grip, training one side at a time, and emphasising a cross-body path — a detail that changes which fibres take the load and how much stability the movement demands. Note the 'Resistance Band Kneeling Cross' component of the name: it specifies how this variation differs from otherwise similar back movements. Support comes from the biceps and rear deltoids; the biceps in particular help bend the elbow and supinate the forearm, which is why fatigue there often shows up before the back is fully worked. Training this with bodyweight needs no equipment at all and can be done virtually anywhere, though it is harder to load progressively once you outgrow it. Most lifters place the Resistance Band Kneeling Cross Body Single Straight Arm Supinated Pulldown in the early portion of a back session. The pattern is accessible enough to learn in a single session, which makes it a sound entry point before progressing to heavier or more complex variations.
The Resistance Band Kneeling Cross Body Single Straight Arm Supinated Pulldown is primarily a back exercise, but it is never only the back doing the work.
The general rule for the Resistance Band Kneeling Cross Body Single Straight Arm Supinated Pulldown is simple: inhale on the lowering phase, exhale as you pull. For heavier sets, take a breath in at the start position, brace as though bracing for a punch, and hold that pressure through the hardest part of the rep before exhaling. Getting this right stabilises your trunk and keeps blood pressure in a sensible range.
Shorten the range of motion to the portion you can control, then extend it as confidence builds. Treat the Resistance Band Kneeling Cross Body Single Straight Arm Supinated Pulldown as skill practice at this stage — the back adapts plenty from clean reps.
Increase total working sets before increasing load — volume drives most of the adaptation at this stage. Hold your Resistance Band Kneeling Cross Body Single Straight Arm Supinated Pulldown load for two sessions before increasing it.
Progress to a heavier variation of the same pattern once technique is stable at your current load. Use the Resistance Band Kneeling Cross Body Single Straight Arm Supinated Pulldown as your accessory once your main back lift is done for the day.
The Resistance Band Kneeling Cross Body Single Straight Arm Supinated Pulldown suits most healthy trainees, but it is not appropriate for everyone.
This is general educational information, not medical advice. If you are managing an injury or medical condition, check with a qualified professional before adding this exercise to your programme.
It primarily trains the back, with the biceps and rear deltoids assisting. The pattern is classified as pull, so the lats, mid-back, rear delts and biceps share the workload.
Yes. It is rated beginner-level, and the pattern can usually be learned in a single session with light resistance.
A practical starting point is 3 sets of 6-8, resting 2-3 min between sets, roughly 2x per week. Adjust from there based on how you recover.
You need bodyweight. This needs no equipment at all and can be done virtually anywhere, though it is harder to load progressively once you outgrow it.
As a general rule, inhale on the lowering phase, exhale as you pull. Avoid holding your breath for the entire set.
Using momentum from the lower back to swing the weight. The simplest correction is to lead with the elbow rather than the hand so the back does the work instead of the arms.
Good substitutes that train the same back pattern include Cable Underhand Pulldown Wide Grips, Barbell Meadows Row, and Cable Bent Over Row. Pick whichever matches the equipment you have available.
Yes. Start each set with your weaker side and match the stronger side to whatever it managed — that is how you close an imbalance rather than reinforce it.
Where the Resistance Band Kneeling Cross Body Single Straight Arm Supinated Pulldown earns its place is repeatability — bodyweight makes the setup easy to reproduce, which is what lets you actually progress the back.
The back is the largest muscle group of the upper body and arguably the most important for posture, strength, and a powerful physique. It is not a single muscle but a layered system: the broad latissimus dorsi that creates width and the V-taper, the trapezius running from the neck to the mid-back, the rhomboids between the shoulder blades, the teres muscles, and the erector spinae that run along the spine and keep you upright.
Because these muscles pull in different directions, no single exercise trains the back completely. The most effective programmes combine two broad categories of movement. Vertical pulls — pull-ups, chin-ups, and lat pulldowns — emphasise the lats and build the width that makes a back look impressive from the front. Horizontal pulls — barbell rows, dumbbell rows, cable rows, and T-bar rows — build thickness through the mid-back, hitting the traps, rhomboids, and lats together. Hip-hinge movements such as the deadlift and rack pull load the entire posterior chain and develop the spinal erectors that protect the lower back.
A well-rounded back session usually includes at least one vertical pull, one horizontal pull, and some direct work for the lower back or traps. Heavy rows and pulldowns respond well to moderate rep ranges around 6 to 10, while deadlifts are typically trained in lower ranges for strength. Because the back is large and recovers well, many lifters train it twice per week with good results.
The biggest technical challenge with back training is actually feeling the back work rather than letting the biceps and forearms take over. Initiate each pull by depressing and retracting the shoulder blades — think about driving your elbows down and back rather than curling the weight with your arms. Keep the chest up, avoid jerking with momentum, and pause briefly in the fully contracted position to maximise tension. On deadlifts and rows, maintain a neutral spine; rounding under heavy load is the most common cause of injury.
Strong back muscles do more than look good. They counterbalance all the pressing and sitting that dominate modern life, pulling the shoulders back into healthy alignment and reducing the slumped posture that leads to neck and shoulder pain. Building your back also directly improves performance on nearly every other lift. Explore the popular back exercises below to assemble a complete pulling routine.