Every movement with step-by-step instructions, the muscles it works, common mistakes and form tips — free, no account needed.
Rated beginner, the Biceps Stretch Behind The Back develops the back through a mobility/flexibility pattern loaded by bodyweight. The muscular job here is to contribute to the movement, and that translates directly into overall performance in this pattern. It sits in the mobility / stretching category, so the emphasis falls on movement quality and repeatable output. Note the 'Biceps Stretch Behind' component of the name: it specifies how this variation differs from otherwise similar back movements. Training this with bodyweight needs no equipment at all and can be done virtually anywhere, though it is harder to load progressively once you outgrow it. Most lifters place the Biceps Stretch Behind The Back in the early portion of a back session. The pattern is accessible enough to learn in a single session, which makes it a sound entry point before progressing to heavier or more complex variations.
The Biceps Stretch Behind The Back is primarily a stretching exercise, but it is never only the stretching doing the work.
The general rule for the Biceps Stretch Behind The Back is simple: breathe slowly and deeply; each exhale lets the tissue release a little further. Keep the breath flowing continuously — there is no need to hold pressure in this pattern. Getting this right stabilises your trunk and keeps blood pressure in a sensible range.
Perform the movement slowly with a light load until the pattern feels automatic. Treat the Biceps Stretch Behind The Back as skill practice at this stage — the back adapts plenty from clean reps.
Add a one- to two-second pause at the hardest position of each repetition. Hold your Biceps Stretch Behind The Back load for two sessions before increasing it.
Slow the lowering phase to three or four seconds to accumulate tension without adding weight. Use the Biceps Stretch Behind The Back as your accessory once your main back lift is done for the day.
The Biceps Stretch Behind The Back suits most healthy trainees, but it is not appropriate for everyone.
This is general educational information, not medical advice. If you are managing an injury or medical condition, check with a qualified professional before adding this exercise to your programme.
It primarily trains the stretching. The pattern is classified as mobility/flexibility, so the the target tissue and its opposing muscle group share the workload.
Yes. It is rated beginner-level, and the pattern can usually be learned in a single session with light resistance.
A practical starting point is 3 sets of 6-8, resting 2-3 min between sets, roughly 2x per week. Adjust from there based on how you recover.
You need bodyweight. This needs no equipment at all and can be done virtually anywhere, though it is harder to load progressively once you outgrow it.
As a general rule, breathe slowly and deeply; each exhale lets the tissue release a little further. Avoid holding your breath for the entire set.
Bouncing into end range instead of easing in. The simplest correction is to ease to the first point of tension, not into sharp pain.
Good substitutes that train the same back pattern include Exercise Ball Lying Side Lat Stretch, Exercise Ball Back Stretch, and Band Standing Rear Delt Row. Pick whichever matches the equipment you have available.
About 2x per week suits most people. Recovery, not frequency, is what limits progress.
The Biceps Stretch Behind The Back fits into that picture as a beginner option using bodyweight that keeps the emphasis on the back.
The back is the largest muscle group of the upper body and arguably the most important for posture, strength, and a powerful physique. It is not a single muscle but a layered system: the broad latissimus dorsi that creates width and the V-taper, the trapezius running from the neck to the mid-back, the rhomboids between the shoulder blades, the teres muscles, and the erector spinae that run along the spine and keep you upright.
Because these muscles pull in different directions, no single exercise trains the back completely. The most effective programmes combine two broad categories of movement. Vertical pulls — pull-ups, chin-ups, and lat pulldowns — emphasise the lats and build the width that makes a back look impressive from the front. Horizontal pulls — barbell rows, dumbbell rows, cable rows, and T-bar rows — build thickness through the mid-back, hitting the traps, rhomboids, and lats together. Hip-hinge movements such as the deadlift and rack pull load the entire posterior chain and develop the spinal erectors that protect the lower back.
A well-rounded back session usually includes at least one vertical pull, one horizontal pull, and some direct work for the lower back or traps. Heavy rows and pulldowns respond well to moderate rep ranges around 6 to 10, while deadlifts are typically trained in lower ranges for strength. Because the back is large and recovers well, many lifters train it twice per week with good results.
The biggest technical challenge with back training is actually feeling the back work rather than letting the biceps and forearms take over. Initiate each pull by depressing and retracting the shoulder blades — think about driving your elbows down and back rather than curling the weight with your arms. Keep the chest up, avoid jerking with momentum, and pause briefly in the fully contracted position to maximise tension. On deadlifts and rows, maintain a neutral spine; rounding under heavy load is the most common cause of injury.
Strong back muscles do more than look good. They counterbalance all the pressing and sitting that dominate modern life, pulling the shoulders back into healthy alignment and reducing the slumped posture that leads to neck and shoulder pain. Building your back also directly improves performance on nearly every other lift. Explore the popular back exercises below to assemble a complete pulling routine.