Every movement with step-by-step instructions, the muscles it works, common mistakes and form tips — free, no account needed.
Rated intermediate, the Barbell Long Landmine Row develops the back through a pull pattern loaded by landmine. The muscular job here is to pull the arms toward and behind the torso, and that translates directly into posture, pulling strength and shoulder health. It sits in the strength category, so the emphasis falls on controlled tension and quality repetitions. The 'Barbell Long Row' designation is not cosmetic — it tells you the specific setup and line of pull that separates this from its close relatives. Support comes from the biceps, rear deltoids, and core; the biceps in particular help bend the elbow and supinate the forearm, which is why fatigue there often shows up before the back is fully worked. Training this with landmine is straightforward to set up and use, though it may not be available in every gym. In a training week, this fits naturally into any session where back is the priority. It assumes you already own the basic pattern and can maintain position under moderate load.
The Barbell Long Landmine Row is primarily a back exercise, but it is never only the back doing the work.
The general rule for the Barbell Long Landmine Row is simple: inhale on the lowering phase, exhale as you pull. For heavier sets, take a breath in at the start position, brace as though bracing for a punch, and hold that pressure through the hardest part of the rep before exhaling. Consistent breathing is what keeps your brace intact from the first rep to the last.
Reduce the load and perform the Barbell Long Landmine Row for higher repetitions, focusing entirely on position rather than weight. If landmine feels unmanageable, rehearse the same pattern with bodyweight first. Film one set of the Barbell Long Landmine Row from the side; it's the fastest way to spot what to fix.
Increase total working sets before increasing load — volume drives most of the adaptation at this stage. Track your Barbell Long Landmine Row numbers so you can see whether the back is actually progressing.
Add a drop set on the last working set to extend the stimulus beyond your normal stopping point. Small, tracked increases on the Barbell Long Landmine Row beat occasional maximal efforts.
The Barbell Long Landmine Row suits most healthy trainees, but it is not appropriate for everyone.
This is general educational information, not medical advice. If you are managing an injury or medical condition, check with a qualified professional before adding this exercise to your programme.
It primarily trains the back, with the biceps, rear deltoids, and core assisting. The pattern is classified as pull, so the lats, mid-back, rear delts and biceps share the workload.
It is rated intermediate. You should already be comfortable with basic back work and able to hold position under moderate load before attempting it.
A practical starting point is 4 sets of 4-6, resting 3 min between sets, roughly 2-3x per week. Adjust from there based on how you recover.
You need landmine. This is straightforward to set up and use, though it may not be available in every gym.
As a general rule, inhale on the lowering phase, exhale as you pull. Avoid holding your breath for the entire set.
Using momentum from the lower back to swing the weight. The simplest correction is to lead with the elbow rather than the hand so the back does the work instead of the arms.
Good substitutes that train the same back pattern include Cable Bent Over Reverse Grip Row, Exercise Ball Lying Side Lat Stretch, and Assisted Chin-up On A Bench. Pick whichever matches the equipment you have available.
Add a small amount of load once you can complete every set at the top of the rep range with clean technique. Keep tempo and range consistent so the comparison is honest.
Where the Barbell Long Landmine Row earns its place is repeatability — landmine makes the setup easy to reproduce, which is what lets you actually progress the back.
The back is the largest muscle group of the upper body and arguably the most important for posture, strength, and a powerful physique. It is not a single muscle but a layered system: the broad latissimus dorsi that creates width and the V-taper, the trapezius running from the neck to the mid-back, the rhomboids between the shoulder blades, the teres muscles, and the erector spinae that run along the spine and keep you upright.
Because these muscles pull in different directions, no single exercise trains the back completely. The most effective programmes combine two broad categories of movement. Vertical pulls — pull-ups, chin-ups, and lat pulldowns — emphasise the lats and build the width that makes a back look impressive from the front. Horizontal pulls — barbell rows, dumbbell rows, cable rows, and T-bar rows — build thickness through the mid-back, hitting the traps, rhomboids, and lats together. Hip-hinge movements such as the deadlift and rack pull load the entire posterior chain and develop the spinal erectors that protect the lower back.
A well-rounded back session usually includes at least one vertical pull, one horizontal pull, and some direct work for the lower back or traps. Heavy rows and pulldowns respond well to moderate rep ranges around 6 to 10, while deadlifts are typically trained in lower ranges for strength. Because the back is large and recovers well, many lifters train it twice per week with good results.
The biggest technical challenge with back training is actually feeling the back work rather than letting the biceps and forearms take over. Initiate each pull by depressing and retracting the shoulder blades — think about driving your elbows down and back rather than curling the weight with your arms. Keep the chest up, avoid jerking with momentum, and pause briefly in the fully contracted position to maximise tension. On deadlifts and rows, maintain a neutral spine; rounding under heavy load is the most common cause of injury.
Strong back muscles do more than look good. They counterbalance all the pressing and sitting that dominate modern life, pulling the shoulders back into healthy alignment and reducing the slumped posture that leads to neck and shoulder pain. Building your back also directly improves performance on nearly every other lift. Explore the popular back exercises below to assemble a complete pulling routine.